Our Products - Coal Tar Epoxy Coating Paint
| TECHNICAL DATA SHEET |
| Product Description |
This is two pack coal tar epoxy coating for metal surfaces . It has good corrosion , abrasion and water resistance. |
| Recommended Uses |
Ideally suitable for use in varied conditions for the protection of all types of metals especially for the substrates which are having marine exposure. |
| PRODUCT SPECIFICATION |
| Mixing Ratio |
Base:Hardener 2:1 |
| Colour |
Black & Brown |
| Finish |
Eggshell - Semiglossy |
| Pot Life |
6 hrs at 30 �C & 65 % Relative Humidity |
| Volume Solids |
60 % � 3 |
| Flash point |
More than 24 �C |
| Recommended DFT |
70 ± 150 microns per coat |
| Covering Capacity |
4 sq.mtrs / ltr for 150 microns ; 8.5 sq.mtr / ltr for 70 microns |
| (Theoretical) |
- |
| Drying Time |
Surface dry – Surface dry – 4 hrs at 30 �C & 65 % Relative Humidity
Hard Dry – 24 hrs max at 30 �C & 65 % Relative Humidity
Fully cured – 7 days |
| Recoating Time |
Min : 6-8 hrs. at 30 �C & 65 % Relative Humidity |
| Method of Application |
Brush / Airless Spray / Conventional Spray |
| Thinner recommended |
' Epicor ’ Thinner |
| Shelf life |
12 months under normal storage conditions in original sealed containers. |
| Surface Preparation |
New Steel : Recommended for abrasive blasting to Sa 2 � after degreasing and deoiling of the surface. If steel is coated by Shop Primer , clean damages to shop primer and clean the surface free from oil , grease , moisture and any other foreign matter. Then to be applied on suitable primer coated surface.
Maintenance : Remove oil , grease etc with a detergent wash. Remove salts and other contaminants by high pressure fresh water hosing. Allow surface to dry before the application.Then to be applied on suitable primer coated surface. |
| Subsequent Coat |
As per recommended coating system. |
| Remarks 1. Application Data |
| Method |
Pressure ( Atm) |
Nozzle |
Thinner |
Thinner volume |
| Brush |
- |
- |
Epicor Thinner |
0 – 5 % |
| Airless Spray |
4 – 5 |
0.018 inch to 0.025 inch
|
Epicor Thinner |
0 – 5 % |
2. Don’t use below 10 �C
3. Stir well before and while using .
4. Film thickness other than indicated also possible.
5. Mix 15 mins before use.
| Safety Precautions : |
| Provide sufficient ventilation while working with solvent based paints in confined spaces and stagnant air. |
Keep the material away from heat , spark and direct flame |
| Avoid inhalation of solvent vapour or paint mist by using facial mask .Use goggles and gloves to protect against direct contact of paint with
skin and eyes. |
In case of contamination , rinse with fresh running water and seek medical help at once. |
| Follow local & national safety rules. |
| Special Comments : |
| Thinner consumption and actual coverage of paint depends on the site conditions. |
Stir the paint well before painting and while painting if necessary. |
| Material should be stored at 30 �C temperature in dry place.
|
