Our Products - Epoxy High Build Finish Paint - Polyamide Hardener
| TECHNICAL DATA SHEET |
| Product Description |
This is two pack cold cure High Build Epoxy Finish Paint cured with polyamide hardener. It has excellent
corrosion resistance in wide range of corrosive conditions. It also has good resistance to abrasion and impact. |
| Recommended Uses |
This product is used as a heavy duty intermediate or finishing coat for structural steel in Chemical, Fertilizer Plants, Power Plants etc. |
| PRODUCT SPECIFICATION |
| Mixing Ratio |
Base : Hardener
4 : 1 |
| Colour |
All Shades as per customer requirement. |
| Finish |
Semiglossy – Glossy |
| Pot Life |
4 – 5 hrs at 30 �C & 65 % Relative Humidity |
| Volume Solids |
60 % � 3 |
| Flash point |
More than 24 �C |
| Recommended DFT |
80 – 120 microns per coat |
| Covering Capacity |
5 to 8 sq.mtrs / ltr |
| (Theoretical) |
- |
| Drying Time |
Surface dry – 2 to 3 hrs at 30 �C & 65 % Relative Humidity
Hard Dry – 10 - 12 hrs max at 30 �C & 65 % Relative Humidity
Fully cured – 7 days |
| Recoating Time |
Min : 10 - 12 hrs. at 30 �C & 65 % Relative Humidity Max : 7 days |
| Method of Application |
Brush / Airless Spray |
| Thinner recommended |
' Epicor ’ Thinner |
| Shelf life |
12 months under normal storage conditions in original sealed containers. |
| Surface Preparation |
Suitably primed surface free from oil , grease , moisture and any other foreign matters. |
| Remarks 1. Application Data |
| Method |
Pressure ( Atm) |
Nozzle |
Thinner |
Thinner volume |
| Brush |
- |
- |
Epicor Thinner |
0 – 5 % |
| Airless Spray |
4 – 5 |
0.018 inch to 0.025 inch
|
Epicor Thinner |
0 – 5 % |
2. Don’t use below 10 �C
3. Stir well before and while using .
4. Film thickness other than indicated also possible.
5. Mix 15 mins before use.
| Safety Precautions : |
| Provide sufficient ventilation while working with solvent based paints in confined spaces and stagnant air. |
Keep the material away from heat , spark and direct flame |
| Avoid inhalation of solvent vapour or paint mist by using facial mask .Use goggles and gloves to protect against direct contact of paint with
skin and eyes. |
In case of contamination , rinse with fresh running water and seek medical help at once. |
| Follow local & national safety rules. |
| Special Comments : |
| Thinner consumption and actual coverage of paint depends on the site conditions. |
Stir the paint well before painting and while painting if necessary. |
| Material should be stored at 30 �C temperature in dry place.
|
