Our Products - Polyurethane Finish Paint
| TECHNICAL DATA SHEET |
| Product Description |
This is a two pack coating based on Acrylic Polyol & Aliphatic Isocynates system. It gives excellent gloss and exterior durability . It retains colour and gloss for a long time and possesses resistance to weather , gasoline , petroleum & oil. |
| Recommended Uses |
Ideally suitable for use as a top coat in Epoxy coating systems for the protection of all types of metals , concretes in all type of environment. |
| PRODUCT SPECIFICATION |
| Mixing Ratio |
Base : Hardener
4 : 1 |
| Colour |
All Shades as per customer requirement. |
| Finish |
Full Glossy ( Matt & Semiglossy are also available ) |
| Pot Life |
6 - 8 hrs at 30 �C & 65 % Relative Humidity |
| Volume Solids |
45 % � 3 |
| Flash point |
More than 24 �C |
| Recommended DFT |
40 � 3 microns per coat |
| Covering Capacity |
11 – 13 sq.mtrs / ltr depending on shade |
| (Theoretical) |
- |
| Drying Time |
Surface dry – 30 to 45 mins at 30 �C & 65 % Relative Humidity.
Hard Dry – 8 - 10 hrs max at 30 �C & 65 % Relative Humidity.
Fully Cured – 7 days |
| Recoating Time |
Min :8 -10 hrs. at 30 �C & 65 % Relative Humidity Max : 7 days at 30 �C & 65 % Relative Humidity |
| Method of Application |
Brush / Conentional Spray /Airless Spray |
| Thinner recommended |
‘ POLYCOR’ Thinner |
| Shelf life |
12 months under normal storage conditions in original sealed containers.
|
| Surface Preparation |
Suitably primed surface free from oil , grease , moisture and any other foreign matters.
|
| Remarks 1. Application Data |
| Method |
Pressure ( Atm) |
Nozzle |
Thinner |
Thinner volume |
| Conventional Spray |
3 – 4 |
|
Polycor Thinner |
5 – 10 % |
| Brush |
- |
-
|
Polycor Thinner |
0 – 5 % |
| Airless Spray |
4 – 5 |
0.018 inch to 0.025 inch
|
Polycor Thinner |
0 – 5 % |
2. Don’t use below 10 �C
3. Stir well before and while using .
4. Film thickness other than indicated also possible.
5. Mix 15 mins before use.
6. Can be applied at different DFTs than indicated.
| Safety Precautions : |
| Provide sufficient ventilation while working with solvent based paints in confined spaces and stagnant air. |
Keep the material away from heat , spark and direct flame |
| Avoid inhalation of solvent vapour or paint mist by using facial mask .Use goggles and gloves to protect against direct contact of paint with
skin and eyes. |
In case of contamination , rinse with fresh running water and seek medical help at once. |
| Follow local & national safety rules. |
| Special Comments : |
| Thinner consumption and actual coverage of paint depends on the site conditions. |
Stir the paint well before painting and while painting if necessary. |
| Material should be stored at 30 �C temperature in dry place.
|
